BS EN 10034:1993 Structural steel I and H sections - Tolerances on shape and dimensio

[ir_71]

BS EN 10034:1993 Structural steel I and H sections - Tolerances on shape and dimensions

Author: ECISS/TC11 | Size: 0.45 MB | Format: PDF | Publisher: CEN | Year: 1993 | pages: 12 | ISBN: 0580219682

This European Standard specifies tolerances on shape dimensions and mass of structural steel I and H sections. These requirements do not apply to I and H sections rolled from stainless steel. These requirements do not apply to taper flange sections.

NOTE Until a European Standard for dimensions of I and H beams is published Euronorm19 and Euronorm53 or corresponding national standards may be used.

Code:

***************************************
Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html
***************************************

Made By CivilEA Post-Generator ver 2.0

[andersen3]

links dead; reposted here:

Code:

***************************************
Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html
***************************************

pass:

Code:

***************************************
Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html
***************************************