BS EN 10034:1993 Structural steel I and H sections - Tolerances on shape and dimensio

BS EN 10034:1993 Structural steel I and H sections - Tolerances on shape and dimensio - Printable Version

+- Civil Engineering Association (https://forum.civilea.com)
+-- Forum: eBooks (https://forum.civilea.com/forum-63.html)
+--- Forum: Codes, Manual & Handbook (https://forum.civilea.com/forum-16.html)
+---- Forum: British Standards (BS) (https://forum.civilea.com/forum-120.html)
+---- Thread: BS EN 10034:1993 Structural steel I and H sections - Tolerances on shape and dimensio (/thread-21359.html)

BS EN 10034:1993 Structural steel I and H sections - Tolerances on shape and dimensio - ir_71 - 01-20-2011

BS EN 10034:1993 Structural steel I and H sections - Tolerances on shape and dimensions

This European Standard specifies tolerances on shape dimensions and mass of structural steel I and H sections. These requirements do not apply to I and H sections rolled from stainless steel. These requirements do not apply to taper flange sections.

NOTE Until a European Standard for dimensions of I and H beams is published Euronorm19 and Euronorm53 or corresponding national standards may be used.

Code:
***************************************

Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html

***************************************

Made By CivilEA Post-Generator ver 2.0

RE: BS EN 10034:1993 - andersen3 - 02-14-2013

links dead; reposted here:

Code:
***************************************

Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html

***************************************

pass:

Code:
***************************************

Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html

***************************************