• Article/eBook Full Name: Vibration analysis of asymmetric shear wall and thin walled open section structures using transfer matrix method
  
• Author(s): Kanat Burak Bozdogan and Duygu Ozturk
  
• Published By: Techno-Press
  
• Related Links:
  
  
  Code:

  ***************************************
Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html
***************************************

Hello felows,

In your opinion, between this software (Autodesk Advanced Concrete 2015) and Autocad structural detailing, which do you think is the best for 3D modeling concrete and reinforcemnt drawings, and also for measure the quantities of concrete and rebar?

Thanks.

your kind help to get this code

BS EN 13381-8:2013 (Test methods for determining the contribution to the fire resistance of structural members. Applied reactive protection to steel members)

It woul be appriciated If you have the articles giiven below and upload them here


MEYERHOF, G. G., and HANNA, A. M. (1978). “Ultimate Bearing Capacity of Foundations on Layered Soil under Inclined Load,” Canadian Geotechnical Journal, Vol. 15, No. 4, pp. 565–572.

MEYERHOF, G. G. (1974). “Ultimate Bearing Capacity of Footings on Sand Layer Overlying Clay,” Canadian Geotechnical Journal, Vol. 11, No. 2, pp. 224–229.

thank you in advance

Dear Colleagues,

Need few papers related to pile foundations in case some of you can share

1. Vertical Vibration of Pile Groups by Mohamed Sheta, (Research Asst., Faculty of Engrg. Sci., Univ. of Western Ontario, London, Ontario, Canada) and Milos Novak, M.ASCE, (Prof., Faculty of Engrg. Sci., Univ. of Western Ontario, London, Ontario, Canada), Journal of the Geotechnical Engineering Division, Vol. 108, No. 4, April 1982, pp. 570-590

2. Flexibility coefficients and Interaction Factors for Pile Group Analysis By El Sharnouby, H. And Novak M. (1986). Canadian Geotechnical Journal, Vol. 23, No. 4, pp. 441-450.

Hello everyone,

As you can see i am new to these forums, I need specific advice on structural analysis and design softwares but i do not know where to post my thread. Can someone tell me which is the most appropriate section to post such a thread so that my post doesn't get deleted?

So that you may properly direct me I want to know which softwares can model, analyse and design monolithic components such as a retaining wall with embedded column and a beam with a slab.

Thank you