[REQUEST] ASTM Standards - ASTM International

[tynhanh]

ASTM E11 - 09e1: Standard Specification for Wire Cloth and Sieves for Testing Purposes

[tynhanh]

ASTM D4373 - 02(2007) Standard Test Method for Rapid Determination of Carbonate Content of Soils

[pelelo]

ASTM D2487 Standard Practice for Classification of Soils for Engineering Purposes (Unified Soil Classification System)

Thanks

[tynhanh]

ASTM D4648 / D4648M - 10 Standard Test Method for Laboratory Miniature Vane Shear Test for SaturatedFine-Grained Clayey Soil

[tynhanh]

ASTM D2216 - 10 Standard Test Methods for Laboratory Determination of Water (Moisture) Content of Soil and Rock by Mass

[rohailiyaz]

Greetings

I need the following astm standard urgently
ASTM A121: Standard Specification for Metallic-Coated Carbon Steel Barbed

This specification covers metallic-coated steel barbed wire, consisting of a strand of two wires.

The barbed wire is available with aluminum, zinc, and zinc-5 % aluminum-mischmetal alloy coatings, with a number of coating weights, in a number of different constructions (designs), and in two grades. Not all designs are available in all coating types.

The values stated in inch-pound units are to be regarded as the standard. The values given in brackets are for information only.

The text of this specification references notes and footnotes that provide explanatory information. These notes and footnotes (excluding those in tables) shall not be considered as requirements of the specification.

barbed wire
carbon steel wire
metallic coated steel wire
steel barbed wire
wire

Regards
Rohail Iyaz

[rohailiyaz]

Can any guide and provide any astm or aci standard for the development length of piles both in tension and compression

Regards
Rohail Iyaz

[whwy99]

Dear all,

Looking for this ASTM. Thx

[rohailiyaz]

Files doesn't exist...can you kindly re upload

[shaker]

ASTM A687-93 Standard Specification for High-Strength Nonheaded Steel Bolts and Studs (Withdrawn 1999)

1. Scope
1.1 This specification covers the chemical and mechanical requirements for quenched and tempered steel nonheaded bolts and studs with enhanced Charpy V-notch impact properties for anchorage and other purposes. The material shall be alloy steel as described in Table 1 and is limited to 5/8 to 3 in. (15.875 to 76 mm) inclusive, in nominal diameter.

1.2 This specification does not apply to mechanical expansion anchors for concrete or to powder-activated nails or studs for concrete or steel.

1.3 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.