AWS D10.7M/D10.7: Guide for the Gas Shielded ArcWelding of Aluminum and Aluminum Allo

[poolmand]

AWS D10.7M/D10.7-2008: Guide for the Gas Shielded ArcWelding of Aluminum and Aluminum Alloy Pipe

| Size: 13.24 MB| Format: PDF| Quality: Scanner| Year: 4th Edition, 2008| pages: 44

This standard provides a summary of recommended industrial practices for welding piping1 fabricated from aluminum alloys. Joint design, welding current, and shielding gas tables are included. This standard makes use of both the International System of Units (SI) and U.S. Customary Units. The measurements may not be exact equivalents; therefore, each system must be used independently of the other without combining in any way. The standard with the designation D10.7M:2000 uses SI Units. The standard designation D10.7:2000 uses U.S. Customary Units. The latter are shown within parenthesis ( ) or in appropriate columns in tables and figures. Pipe sizes are listed as DN (diameter nominal) and NPS (nominal pipe size). The exact pipe diameters are listed in Table 13.

Code:

***************************************
Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html
***************************************

Code:

***************************************
Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html
***************************************

Code:

***************************************
Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html
***************************************

This post has been made by CivilEA Post-Generator V2.4.2