AWS D3.7: Guide for Aluminum Hull Welding

[poolmand]

AWS D3.7-2004: Guide for Aluminum Hull Welding

| Size: 19.24 MB| Format: PDF| Quality: Scanner| Year: 2004 Edition, 2004| pages: 87

This standard makes sole use of U.S. Customary Units. Approximate mathematical equivalents in the International System of Units (SI) are provided for comparison in parentheses or in appropriate columns in tables and figures.

This guide provides information on proven processes, techniques, and procedures for welding aluminum hulls and related ship structures. The information presented applies chiefly to the welding of aluminum hulls that are over 30 ft (9 m) in length and made of sheet and plate 1/8 in. (3.2 mm) thick and greater. Thin-gage aluminum welding usually requires specific procedures in the area of fixturing, welding sequence, and other techniques for distortion control that are not necessarily applicable to thick plates. Similarly, the choice of welding process or applicable process conditions, or both, also differs according to thickness.

Code:

***************************************
Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html
***************************************

Code:

***************************************
Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html
***************************************

Code:

***************************************
Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html
***************************************

This post has been made by CivilEA Post-Generator V2.4.2