Time history analysis as a method of implementing

[aslam]

Time history analysis as a method of implementing performance based design

info:
The current loadings code, NZS4203:1992 (Standards NZ, 1992) permits the use of time history analysis for all structures but the procedures are non-prescriptive and open to varying interpretation, particularly in the selection and scaling of time history records. Scaling of at least three records is required such that “over the period range of interest … the 5% damped spectrum of the earthquake record does not differ significantly from the design spectrum”. In practice, this has usually been interpreted so as to scale records to provide approximately the same average spectrum as the design spectrum.

[attachment=830]

[Grunf]

Direct link:

Code:

***************************************
Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html
***************************************

[cve_jule]

Just as a contribution to this (or any similar) post.

Go to

Code:

***************************************
Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html
***************************************

In the search box write:

Code:

***************************************
Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html
***************************************

It will give you all of the *.pdf documents that are stored on that site. In this particular example, there will be around 800 pdf papers.