Mechanics of Fiber Reinforced Bearings

[kowheng]

Mechanics of Fiber Reinforced Bearings

Author: Kelly, James M.; Calabrese, Andrea | Size: 2.17 MB | Format: PDF | Quality: Unspecified | Publisher: Pacific Earthquake Engineering Research (PEER) Center, University of California, Berkeley, Authors retain copyright | Year: 2012-02 | pages: 110

Mechanics of fiber reinforced bearings

Kelly, James M.; Calabrese, Andrea

PEER-2012/101, Pacific Earthquake Engineering Research (PEER) Center, University of California, Berkeley, Authors retain copyright, 2012-02, PDF (400/P33/2012-101)

The report contains the findings of a study on the mechanical behavior of unbonded fiber-reinforcedbearings (FRB). Typical FRBs consist of several layers of rubber that are bonded to fiber reinforcing sheets. The purpose of the reinforcement is to prevent the rubber from bulging laterally under compressive load. The most important aspects of these bearings are (i) they do not have thick end plates; (ii) they are not bonded to the top and bottom support surfaces; and (iii) their reinforcements are very flexible. These aspects may seem to be design deficiencies, but they have the advantage of eliminating the presence of tensile stresses in the bearing by allowing it to roll off the supports when it is sheared. This reduces the typical bonding requirements. The weight and the cost of isolators is reduced by using fiber reinforcing, no end-plates, and no bonding to the support surfaces, offering a low-cost lightweight isolation system for developing countries. This work is the comparison between an approximated linear elastic theory and the outputs of finite element analyses.

Code:

***************************************
Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html
***************************************

Code:

***************************************
Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html
***************************************

This post has been made by CivilEA Post-Generator ver 2.1.6