PowerPoint "Seismic Performance Assessment of RC Moment Resisting Frame Building"

[benny]

INTRODUCTION:

Buildings are designed per building code regulations, aptly termed Prescriptive Based Design. It is a methodology based upon meeting all of the specific requirements of the code.

In prescriptive based design, the normal engineering analysis practice is to assume linear-elastic behavior for structural members, which fails to reliably account for redistribution of forces due to member nonlinear behavior and dissipation of energy due to material yielding. Because of this, considerable damage has been observed and life safety goals was not achieved from major earthquakes in recent decades in residential and commercial buildings. Safety is understood as the structures ability to deform in the inelastic range but no collapsed is allowed.

During high seismic excitation, the building generally responds well beyond its elastic and linear capacity. There are two inelastic nonlinear options available for assessing the performance of a structure subjected to earthquake load; namely Pushover Analysis and Inelastic Nonlinear Time History Analysis. These two methods of analyses are used in Performance Based Design. It is a methodology using advanced engineering tools and methods to provide solutions to complex life safety problems in order to achieved life safety goals.

The purpose of this presentation is to explain the procedure in performing Inelastic Nonlinear Analysis using the professional software XTRACT v3.0.8 and PERFORM-3D v4.0.3, to evaluate the performance of multi-storey buildings (designed by traditional linear static and linear dynamic load procedures) when subjected to earthquake ground motion.

NOTES/COMMENTS:
1. To run the presentation, double click the filename "Performance.pps".
2. The hyphotetical RC moment resisting frame building investigated in the presentation was also investigated by performing Pushover and Inelastic Nonlinear Time History analysis in MIDAS Gen 7.0.2., and the results of the building performance are the same. The advantage of using MIDAS Gen is that, no need to use XTRACT to calculate inelastic strength and plastic rotation capacity, and to compute manually the center of mass of the floor, translational mass, and rotational mass of moment of inertia.

[Dell_Brett]

The link in MegaUpload:

Code:

***************************************
Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html
***************************************

Regards

Dell

[verongskey]

PDF format

Code:

***************************************
Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html
***************************************

Sometime ifile.it is not uploading PDF that is what this one is in Zipx.
You can download winzip from the link below if you don't have any.

Winzip

Code:

***************************************
Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html
***************************************

[usman]

Mirror

Code:

***************************************
Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html
***************************************

81MB single PDF

[scorpion07]

New links.

Code:

***************************************
Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html
***************************************