BS 8118 Structural use of aluminium
Author: Committee B/525/9 | Size: 16.61 MB | Format: PDF | Publisher: BSI | Year: 1999 | pages: 160 | ISBN: 0580192091
This Part of BS 8118 provides recommendations for the design of the elements of framed, lattice and stiffened plate structures, using wrought aluminium alloy. The design recommendations are for a variety of aluminium alloys suitable for structural use, and apply to a range of structures subjected to normal atmospheric conditions such as bridges, buildings, towers, road and rail vehicles, marine craft, cranes and offshore topside structures.
This British Standard does not cover aerospace alloys, the detail design of castings, curved shell structures or structures subjected to severe thermal or chemical conditions. It is not intended to be used for the design of containment vessels, pipework, airborne structures or naval vessels.
This British Standard does not cover aerospace alloys, the detail design of castings, curved shell structures or structures subjected to severe thermal or chemical conditions. It is not intended to be used for the design of containment vessels, pipework, airborne structures or naval vessels.
Code:
***************************************
Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:
http://forum.civilea.com/thread-27464.html
***************************************
Author: Committee B/525/9 | Size: 2.96 MB | Format: PDF | Publisher: BSI | Year: 1999 | pages: 28 | ISBN: 0580192105
This part of BS 8118 specifies requirements for the materials, workmanship and protection of aluminium and aluminium alloy construction and structures.
The requirements of this standard apply to the fabrication, protection, assembly and erection of aluminium and aluminium alloy construction, but the engineer undertaking the design needs to be aware of those items which will affect the design.
Guidance on fabrication tolerances, erection tolerances and assembly tolerances is given in appendix A. Guidance on weld inspection acceptance levels is covered in appendix B.
The requirements of this standard apply to the fabrication, protection, assembly and erection of aluminium and aluminium alloy construction, but the engineer undertaking the design needs to be aware of those items which will affect the design.
Guidance on fabrication tolerances, erection tolerances and assembly tolerances is given in appendix A. Guidance on weld inspection acceptance levels is covered in appendix B.
Code:
***************************************
Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:
http://forum.civilea.com/thread-27464.html
***************************************