Effects of Transverse Reinforcement and Bonded length on the Side-Blowout Capacity of Headed Reinforcement
Current time: 04-13-2021, 04:53 AM
Users browsing this thread: 1 Guest(s)
Author: yucapareja
Last Post: zbizafar
Replies 1
Views 2377

Effects of Transverse Reinforcement and Bonded length on the Side-Blowout Capacity of Headed Reinforcement
#1
Hi everyone, I hope someone can upload this paper:

Title: Effects of Transverse Reinforcement and Bonded length on the Side-Blowout Capacity of Headed Reinforcement
Author(s): R. A. DeVries, J. O. Jirsa and T. Bashandy
Publication: Special Publication
Volume: 180
Pages: 367-390
Keywords: Anchorage; bonding; reinforced concrete; slip; transverse reinforcement
Date: October 1, 1998

Abstract:

Pullout tests were conducted on deeply embedded headed reinforcement to determine the effect of transverse reinforcement and bonded length on the side-blowout capacity and load-slip behavior of the anchorage. It was found that transverse ties or stirrups in the anchorage zone had little effect on the ultimate capacity. Increases in anchorage capacity were only observed when the head was positively anchored in contact behind a large crossing bar. Transverse reinforcement also had little effect on the load-slip behavior before failure. However, when large amounts of transverse reinforcement were placed near the head, the amount of load maintained after the blowout failure occurred was increased. Additional bonded length of a deformed reinforcing bar increased the anchorage capacity and reduced the head slip for a given load. The amount of increase in capacity can be predicted using current ACI provisions for development length. Design procedures taking into account the effects of transverse reinforcement and bonded length were developed.

***************************************
Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html
***************************************

Thanks in Advance
Reply
#2
SP180-16

[Image: info.png]
Effects of Transverse Reinforcement and Bonded length on the Side-Blowout Capacity of Headed Reinforcement



[Image: Download.png]

***************************************
Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html
***************************************

[-] The following 9 users say Thank You to zbizafar for this post:
  • user, concreteok, robertsas, Grunf, yucapareja, pssst, oanm2000, pram, sodapas
Reply


Possibly Related Threads…
Thread Author Replies Views Last Post
Design of Anchor Reinforcement for Seismic Shear Loads asim99 0 1,847 03-17-2013, 01:08 AM
Last Post: asim99
Guideline for Subgrade Reinforcement with Geosynthetics ir_71 0 1,563 06-01-2011, 05:32 PM
Last Post: ir_71
Geosynthetics Reinforcement in Waste Containment Applications ir_71 0 1,509 05-30-2011, 05:50 AM
Last Post: ir_71
REINFORCEMENT HANDBOOK ir_71 1 2,360 03-10-2011, 04:15 AM
Last Post: adams
ASCE - Optimal Steel Fiber Strength for Reinforcement of Cementitious Materials datagap 1 2,176 01-23-2011, 09:44 PM
Last Post: psa_1987



Users browsing this thread: 1 Guest(s)