Civil Engineering Association
Effects of Transverse Reinforcement and Bonded length on the Side-Blowout Capacity of Headed Reinforcement - Printable Version

+- Civil Engineering Association (https://forum.civilea.com)
+-- Forum: eBooks (https://forum.civilea.com/forum-63.html)
+--- Forum: Journals, Papers and Presentations (https://forum.civilea.com/forum-74.html)
+--- Thread: Effects of Transverse Reinforcement and Bonded length on the Side-Blowout Capacity of Headed Reinforcement (/thread-11383.html)

Effects of Transverse Reinforcement and Bonded length on the Side-Blowout Capacity of Headed Reinforcement - yucapareja - 04-28-2010

Hi everyone, I hope someone can upload this paper:

Title: Effects of Transverse Reinforcement and Bonded length on the Side-Blowout Capacity of Headed Reinforcement
Author(s): R. A. DeVries, J. O. Jirsa and T. Bashandy
Publication: Special Publication
Volume: 180
Pages: 367-390
Keywords: Anchorage; bonding; reinforced concrete; slip; transverse reinforcement
Date: October 1, 1998

Abstract:

Pullout tests were conducted on deeply embedded headed reinforcement to determine the effect of transverse reinforcement and bonded length on the side-blowout capacity and load-slip behavior of the anchorage. It was found that transverse ties or stirrups in the anchorage zone had little effect on the ultimate capacity. Increases in anchorage capacity were only observed when the head was positively anchored in contact behind a large crossing bar. Transverse reinforcement also had little effect on the load-slip behavior before failure. However, when large amounts of transverse reinforcement were placed near the head, the amount of load maintained after the blowout failure occurred was increased. Additional bonded length of a deformed reinforcing bar increased the anchorage capacity and reduced the head slip for a given load. The amount of increase in capacity can be predicted using current ACI provisions for development length. Design procedures taking into account the effects of transverse reinforcement and bonded length were developed.

Code:
***************************************
Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html
***************************************
Thanks in Advance

RE: ACI Paper - zbizafar - 04-29-2010

SP180-16

[Image: info.png]
Effects of Transverse Reinforcement and Bonded length on the Side-Blowout Capacity of Headed Reinforcement



[Image: Download.png]

Code:
***************************************
Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html
***************************************