BS 0-2011 A standard for standards – Principles of standardization

andersen3 · (This post was last modified: 02-07-2013, 11:16 AM by andersen3.)

BS 0,A standard for standards, is the main document by which BSI sets out how British Standards and related documents are developed and maintained.
This edition of BS 0 is in a single part, covering broadly the same scope as BS 0-1:2005. The drafting rules previously specified in BS 0-2:2005 have been replaced by a version of the ISO/IEC Directives, Part 2:Rules for the drafting and
presentation of International Standards[N1], which incorporates much of the BSI-specific drafting guidance previously presented in other documents.
Reverting to earlier practice, the provisions of this British Standard are not expressed as absolute requirements, but as principles. These establish the basis on which common expectations can confidently be held, whilst allowing some
flexibility in interpretation and application. The exercise of this flexibility has to be based on a soundly reasoned consideration of what is appropriate, reasonable, necessary and practicable in any particular context. This approach is intended to provide an effective framework for British Standards to support the
increasingly diverse markets and circumstances in which they are developed and applied.

Replaces BS 0-1:2005 and BS 0-2:2005 which remain current.

Code:
***************************************

Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html

***************************************

Code:
***************************************

Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html

***************************************

This post has been made by CivilEA Post-Generator ver 2.1.6