05-02-2013, 11:20 AM
ACI_318-08_Rec_Sec._Mx_-Q-Torsion_Design_Rev06_02-May-2013.xlsx
REV 06:
1- adding row 66 which was removed by mistake in rev 05,this row show a message to change the cross-section for torsion,and have the following equation "=IF(D64<=G64,"Section Dimension is OK for tosion","Change Section Dimension for torsion")"
2- changing the text message in the following cells: G36, G37, G50, F61, B66
3-3- Rearranging the Stirrups claculation for shear and torsion, from row 69 to end
the outter stirrups supports the torsion + part of shear forces the inner stirrups supports the rest of shear force
4- changing the calculation of stirrups RFT. To be Av/S & At/S , to be easy to compared with Etabs Value in row 51, 53, 67, 68
REV 06:
1- adding row 66 which was removed by mistake in rev 05,this row show a message to change the cross-section for torsion,and have the following equation "=IF(D64<=G64,"Section Dimension is OK for tosion","Change Section Dimension for torsion")"
2- changing the text message in the following cells: G36, G37, G50, F61, B66
3-3- Rearranging the Stirrups claculation for shear and torsion, from row 69 to end
the outter stirrups supports the torsion + part of shear forces the inner stirrups supports the rest of shear force
4- changing the calculation of stirrups RFT. To be Av/S & At/S , to be easy to compared with Etabs Value in row 51, 53, 67, 68
Code:
***************************************
Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:
http://forum.civilea.com/thread-27464.html
***************************************