Forces in Plastic Vertical Drains during installation

[shadabg]

Forces in Plastic Vertical Drains during installation

Author: Nico Cortlever & Ger Dijst | Size: 1.55 MB | Format: PDF | Quality: Original preprint | pages: 7

ABSTRACT:

During installation of Plastic Vertical Drains (PVD) large forces can occur that rupture the drain or filter fabric. To determine these forces laboratory and field tests are executed whereby the forces are measured by strain gages during installation of the drains. The tests showed that under circumstances these forces could exceed the requirements mentioned in certain norms. The forces were caused by the fact that high performance PVD installation rigs were used in combination with large depths and hard top layers. Also other circumstances can influence the forces in drains during installation. This paper describes all the factors that influence the forces in PVD.

Code:

***************************************
Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html
***************************************

Code:

***************************************
Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html
***************************************

This post has been made by CivilEA Post-Generator ver 2.1.6

[tomcat007]

All,

Can someone repost this paper? All links are dead.

Regards,