11-28-2010, 02:22 PM
Dear Dell Bret,
We can use frame model (1-5 m section), from your drawing I think we can anlayse for 5 frames, using the greater height to design for reinforcement for each section. Don't forget to apply point load from equipment supporting point.
For culvert structure, I think this method will be enough. Don't be worry to much about heavy reinforcement, it's better than it fail.
Regards,
We can use frame model (1-5 m section), from your drawing I think we can anlayse for 5 frames, using the greater height to design for reinforcement for each section. Don't forget to apply point load from equipment supporting point.
For culvert structure, I think this method will be enough. Don't be worry to much about heavy reinforcement, it's better than it fail.
Regards,