09-03-2010, 12:33 PM
Dear Donmehdi
I am not sure whether you have applied mesh from ram concept to Etabs. I think it causes a lot of messy. Even I try import one simple drawing in dxf file to etabs , it is somehow to shift away my point (even it is really small but very annoy to modify it again). I think the best way to manual mesh is draw the big square or rectangle to connect 4 columns then divide it to small elements. then use shrink point to match with close other proximity points . Any suggestion.
Regards
I am not sure whether you have applied mesh from ram concept to Etabs. I think it causes a lot of messy. Even I try import one simple drawing in dxf file to etabs , it is somehow to shift away my point (even it is really small but very annoy to modify it again). I think the best way to manual mesh is draw the big square or rectangle to connect 4 columns then divide it to small elements. then use shrink point to match with close other proximity points . Any suggestion.
Regards