01-31-2011, 06:55 AM
I never sent any computer file to client!
Normally I only sent:
1- Summary of Geometry data;
2- Summary of Design criteria;
3- Loads considerations (if is different from the Country Code);
4- Loads combination;
5- Output data (results) - Can include graphics;
6- Specific design criteria (if occurs) - (Including concrete cast sequence/joints);
7- Notes about minimal time to remove form and supports, minimum Ec and Fck, etc.
In most cases the items 1- to 4- is the input data report of the program, and the item 5- is the output data.
The computer file ONLY be send if is explicit in contract, with restrictions of use/share! They must be considered your intellectual propriety!
Regards
Dell Brett
Normally I only sent:
1- Summary of Geometry data;
2- Summary of Design criteria;
3- Loads considerations (if is different from the Country Code);
4- Loads combination;
5- Output data (results) - Can include graphics;
6- Specific design criteria (if occurs) - (Including concrete cast sequence/joints);
7- Notes about minimal time to remove form and supports, minimum Ec and Fck, etc.
In most cases the items 1- to 4- is the input data report of the program, and the item 5- is the output data.
The computer file ONLY be send if is explicit in contract, with restrictions of use/share! They must be considered your intellectual propriety!
Regards
Dell Brett