10-12-2010, 05:06 PM
You must assign rigid diaphragm to floor (area/joint) by use assign diaphragm
When you assign load case, select wind load type and you can select auto standard such as ASCE7-05 it will automatically applied load to diaphragm.
Also you can choose user define in wind load case to assign the value of wind load to each floor diaphragm in term of table.
When you assign load case, select wind load type and you can select auto standard such as ASCE7-05 it will automatically applied load to diaphragm.
Also you can choose user define in wind load case to assign the value of wind load to each floor diaphragm in term of table.