hi
probalby the best solution it´s to export them into another format like dxf ,,, combine them ,,, and import the geometry again but i am not sure.
hi
the best way i think is :
1) in one of the models be sure that the beams, columns, slabs labels etc...are diferente from the other model.
2 )export both models as *.e2k
3) edit one e2k file with notepad ,,, cut and paste information from one to another
4) in etabs import the final *.e2k file
pf corse that is importante that that the model dont share the same global coordinates,,,, do a translation in one of the models if needed.
that sould do , this is simplified i did not tried the procedure, but in the old days there was no GUI(pre-processor) for SAP90 so we had to edit a text file and this is how we did it.
teste and give feedback please.
regards
probalby the best solution it´s to export them into another format like dxf ,,, combine them ,,, and import the geometry again but i am not sure.
hi
the best way i think is :
1) in one of the models be sure that the beams, columns, slabs labels etc...are diferente from the other model.
2 )export both models as *.e2k
3) edit one e2k file with notepad ,,, cut and paste information from one to another
4) in etabs import the final *.e2k file
pf corse that is importante that that the model dont share the same global coordinates,,,, do a translation in one of the models if needed.
that sould do , this is simplified i did not tried the procedure, but in the old days there was no GUI(pre-processor) for SAP90 so we had to edit a text file and this is how we did it.
teste and give feedback please.
regards