11-10-2009, 06:20 AM
Hi, Guys
I had done meshing by using two softwares...
Import the dxf file into ROBOT, you have a meshing option there which will mesh the areas into rectangle/quadrilateral, from there saveas dxf again and import into ETABS. But after importing check for overalping areas if any. It gave good results and finer meshing for me.
You can try the above.
Regards,
Jaks
I had done meshing by using two softwares...
Import the dxf file into ROBOT, you have a meshing option there which will mesh the areas into rectangle/quadrilateral, from there saveas dxf again and import into ETABS. But after importing check for overalping areas if any. It gave good results and finer meshing for me.
You can try the above.
Regards,
Jaks
![[-]](https://forum.civilea.com/images/collapse.png)