10-29-2010, 05:32 AM
Thanks zipatton foir the prompt reply.
The problem is not what you have spelled out above. All that is clear and understood by me. The issue is under the "Load combination name" input, instead of UNCON1, UDCON2,UDCON3..........I would like to enter my own load combination description other than the defaulted one, say i type 1.4DL+1.6LL as is the case with SAP2000, this will help me to easily refer back.
The problem is if i use UDCON1....... I always have to go back and check what the combination name involves whether only dead load, live load+dead load,etc. But if i use my own name description, voila!!!!!!
The problem is not what you have spelled out above. All that is clear and understood by me. The issue is under the "Load combination name" input, instead of UNCON1, UDCON2,UDCON3..........I would like to enter my own load combination description other than the defaulted one, say i type 1.4DL+1.6LL as is the case with SAP2000, this will help me to easily refer back.
The problem is if i use UDCON1....... I always have to go back and check what the combination name involves whether only dead load, live load+dead load,etc. But if i use my own name description, voila!!!!!!