10-17-2010, 03:58 AM
The purpose of staad section command is not what you are expecting that if you cut a section in a wall it will show the reinforcements in that particular wall. Staad is not a drafting software where the section implies that you can see what is inside in the element being cut through.
The purpose of section command in staad is to be able to isolate certain levels/section in your frame for easy viewing and easy selection and application of properties and loads in your frame this is very handy for a very complex model like high rise and commercial buildings.
The purpose of section command in staad is to be able to isolate certain levels/section in your frame for easy viewing and easy selection and application of properties and loads in your frame this is very handy for a very complex model like high rise and commercial buildings.