05-30-2009, 01:59 AM
After analysis, check the moments i.e M11,M22 ? how the contours are forming... with this you can easily know the shape and width of the strip? then you can draw the strips and run the analysis and detail it....
Frank
Frank
(04-06-2009, 04:37 PM)aslam Wrote: Instead of going for inclined strips for irregular building, go for GENERAL FEM DESIGN. Provide minimum required steel in both direction, both face as per code req. and provide additional (extra) steel where needed.
Regards
(04-06-2009, 12:50 PM)Yasir Wrote: How to cut Inclined Strips in SAFE?
for an irregular building how to design for reinforcement?