04-07-2009, 02:08 PM
If u have complex shape building, there must be some complication in reinforcement detailing. u can not have regular column or middle strips.
actually, inclined strips will be more difficult to handle.
so, provide min steel throughout. add extra steel where needed. take care about min clear distance between bars 9continuous & extra). extend extra bars for distance d from theoritical cut-off point.
regards
actually, inclined strips will be more difficult to handle.
so, provide min steel throughout. add extra steel where needed. take care about min clear distance between bars 9continuous & extra). extend extra bars for distance d from theoritical cut-off point.
regards
(04-07-2009, 06:39 AM)Yasir Wrote: but will it not be troublesome to handle a K shaped building to do like that... isn't there any more handy approach
(04-06-2009, 04:37 PM)aslam Wrote: Instead of going for inclined strips for irregular building, go for GENERAL FEM DESIGN. Provide minimum required steel in both direction, both face as per code req. and provide additional (extra) steel where needed.