LIMIT STATES DESIGN OF CRANE RUNWAY GIRDERS

[poolmand]

LIMIT STATES DESIGN OF CRANE RUNWAY GIRDERS

Author(s)/Editor(s): N S TRAHAIR | Size: 503 KB | Format: PDF | Quality: Original preprint | Year: Jan 2021 | pages: 17 

 Publisher: School of Civil Engineering, The University of Sydney

RESEARCH REPORT R967
Steel crane runway girders are subjected to torsion by their eccentric loads. The twist rotation of the principal axes caused by torsion induces additional bending moments, and reduces the resistance to lateral buckling. There is little guidance on how to design for torsion, and design procedures are often intuitive, with varying degrees of rationality and precision.
This paper seeks to establish a logical procedure for designing crane runway girders which is based on an extension of the limit states methods of designing for biaxial bending. An additional term for the ratio of the design torque to the section torsion resistance is included in the interaction equations. Proposals are made for determining this section resistance. Research has shown that this addition can allow for the reduction in the lateral buckling resistance caused by the twist rotations. A linear elastic analysis of the twist rotations is used to determine the moment increases caused by torsion.
An example of the proposed method is developed and illustrated by a design example. The small twist rotations are not enough to have a major effect on the bending moments. The additional torsion term is also small, and the design capacity is primarily governed by the resistance to lateral buckling.

Code:

Content of this section is hidden, You must be registered and upgrade your account to see this content.

🔽🔽🔽🔽🔽🔽🔽🔽🔽
See this link to read how you can remove this limitation:
👉 CLICK HERE 👈

Code:

Content of this section is hidden, You must be registered and upgrade your account to see this content.

🔽🔽🔽🔽🔽🔽🔽🔽🔽
See this link to read how you can remove this limitation:
👉 CLICK HERE 👈

This post has been made by CivilEA Post-Generator V2.3.1