REFLECTION OF SEISMIC WAVES FROM ATTENUATING AND ANISOTROPIC OCEAN BOTTOM SEDIMENTS A

REFLECTION OF SEISMIC WAVES FROM ATTENUATING AND ANISOTROPIC OCEAN BOTTOM SEDIMENTS A - Printable Version

+- Civil Engineering Association (https://forum.civilea.com)
+-- Forum: eBooks (https://forum.civilea.com/forum-63.html)
+--- Forum: General Books (https://forum.civilea.com/forum-54.html)
+---- Forum: Civil Engineering MSc and PhD thesis (https://forum.civilea.com/forum-124.html)
+---- Thread: REFLECTION OF SEISMIC WAVES FROM ATTENUATING AND ANISOTROPIC OCEAN BOTTOM SEDIMENTS A (/thread-44494.html)

REFLECTION OF SEISMIC WAVES FROM ATTENUATING AND ANISOTROPIC OCEAN BOTTOM SEDIMENTS A - TAFATNEB - 09-01-2013

REFLECTION OF SEISMIC WAVES FROM ATTENUATING AND ANISOTROPIC OCEAN BOTTOM SEDIMENTS

There is an increasing trend towards recording marine seismic data directly on the seafloor.
This acquisition strategy is mainly motivated by the possibility to simultaneously measure
the three components of particle motion in addition to the pressure in the water column
immediately above the seabed. Such four-component (4C) seismic recordings thus allow
for the recording of S-waves in marine environments and offer the prospect of decomposing
the wavefield into its up- and down-going P- and S-wave constituents.
The assumptions for acquisition and processing of 4C data is today based on the ocean
bottom model as a welded acoustic-elastic contact at the seabed with a homogeneous
acoustic layer overlying a homogeneous elastic half-space. This may not hold in wide
areas of the oceans where the seafloor typically consists of soft, water-saturated sediments
characterized by having strong to very strong seismic attenuation. Moreover, cyclically
changing sedimentation processes lead to layering in the sediments, thus introducing
macroscopic seismic anisotropy, and overburden pressure and associated compaction effects
are likely to result in a strong velocity gradients.

Code:
***************************************

Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html

***************************************

This post has been made by CivilEA Post-Generator v2.2.0

RE: REFLECTION OF SEISMIC WAVES - andersen3 - 11-29-2013

direct link

Code:
***************************************

Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html

***************************************