ANSI/NAAMM FP 1001-07 GUIDE SPECIFICATIONS FOR DESIGN OF METAL FLAGPOLES

ANSI/NAAMM FP 1001-07 GUIDE SPECIFICATIONS FOR DESIGN OF METAL FLAGPOLES - Printable Version

+- Civil Engineering Association (https://forum.civilea.com)
+-- Forum: eBooks (https://forum.civilea.com/forum-63.html)
+--- Forum: Codes, Manual & Handbook (https://forum.civilea.com/forum-16.html)
+--- Thread: ANSI/NAAMM FP 1001-07 GUIDE SPECIFICATIONS FOR DESIGN OF METAL FLAGPOLES (/thread-25134.html)

ANSI/NAAMM FP 1001-07 GUIDE SPECIFICATIONS FOR DESIGN OF METAL FLAGPOLES - ir_71 - 04-28-2011

1.1 These specifications set forth the procedures for determining the design loads for metal flagpoles of hollow circular cross section.
1.2 The method for determining the wind speed and resulting wind load on the pole is part of these specifications.
1.3 The method for determining the wind load on the flag and the resulting load imposed on the pole is part of these specifications also.
1.4 Methods of analysis are given with sample calculations for a typical flagpole.
1.5 Minimum properties of materials typically used in the design of flagpoles are included.

Code:
***************************************

Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html

***************************************

Made By CivilEA Post-Generator ver 2.1

RE: ANSI/NAAMM FP 1001-07 GUIDE SPECIFICATIONS FOR DESIGN OF METAL FLAGPOLES - CAMSECT - 09-27-2020

please new link.

RE: ANSI/NAAMM FP 1001-07 GUIDE SPECIFICATIONS FOR DESIGN OF METAL FLAGPOLES - civilfafa - 09-28-2020

Please find the link:

Code:
***************************************

Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html

***************************************