[REQUEST] ISO 128 - Printable Version +- Civil Engineering Association (https://forum.civilea.com) +-- Forum: eBooks (https://forum.civilea.com/forum-63.html) +--- Forum: Books, Codes, Theses, Journals & Papers Request (https://forum.civilea.com/forum-55.html) +---- Forum: Archive (https://forum.civilea.com/forum-176.html) +---- Thread: [REQUEST] ISO 128 (/thread-21119.html) |
ISO 128 - adnandj - 01-11-2011 Hi, i would need ISO 128 standard or any other book for standards for civil engineering drawings in PDF! Could anybody, please put a link here! Thank you! RE: ISO 128 - ir_71 - 01-11-2011 Dear friend, ISO 128 is not single standard, it it series of stadards - over 40 standards. You have to specify an exact number of the standard. Regards RE: ISO 128 - adnandj - 01-11-2011 Aha! thank for reminder :) I would need this standards if u can find it * ISO 128-1:2003. Technical drawings—General principles of presentation—Part 1: Introduction and index * ISO 128-20:1996 Technical drawings—General principles of presentation—Part 20: Basic conventions for lines * ISO 128-21:1997 Technical drawings—General principles of presentation—Part 21: Preparation of lines by CAD systems * ISO 128-22:1999 Technical drawings—General principles of presentation—Part 22: Basic conventions and applications for leader lines and reference lines * ISO 128-23:1999 Technical drawings—General principles of presentation—Part 23: Lines on construction drawings * ISO 128-24:1999 Technical drawings—General principles of presentation—Part 24: Lines on mechanical engineering drawings ... i hope that isnt too much worl! Thank you!! * ISO 128-25:1999 Technical drawings—General principles of presentation—Part 25: Lines on shipbuilding drawings * ISO 128-30:2001 Technical drawings—General principles of presentation—Part 30: Basic conventions for views * ISO 128-34:2001 Technical drawings—General principles of presentation—Part 34: Views on mechanical engineering drawings * ISO 128-40:2001 Technical drawings—General principles of presentation—Part 40: Basic conventions for cuts and sections * ISO 128-44:2001 Technical drawings—General principles of presentation—Part 44: Sections on mechanical engineering drawings * ISO 128-50:2001 Technical drawings—General principles of presentation—Part 50: Basic conventions for representing areas on cuts and sections RE: ISO 128 - ir_71 - 01-11-2011 Code: *************************************** Code: *************************************** Code: *************************************** Code: *************************************** Code: *************************************** Code: *************************************** Code: *************************************** Code: *************************************** Code: *************************************** ISO 128 - ir_71 - 09-24-2013 Code: *************************************** Code: *************************************** RE: ISO 128 - Photon - 06-11-2019 Can someone please re-upload this? thanks |