Design of End Block Reinforcement of Post-Tensioned Girder - Printable Version +- Civil Engineering Association (https://forum.civilea.com) +-- Forum: Civil Engineering Resource (https://forum.civilea.com/forum-1.html) +--- Forum: Civil Engineering Documents (https://forum.civilea.com/forum-89.html) +---- Forum: Engineering Spreadsheet (https://forum.civilea.com/forum-43.html) +---- Thread: Design of End Block Reinforcement of Post-Tensioned Girder (/thread-19592.html) |
Design of End Block Reinforcement of Post-Tensioned Girder - kowheng - 12-04-2010 Design of End Block Reinforcement of Post-Tensioned Girder
Design of End Block Reinforcement of Post-Tensioned Girder Unit: ton, m, ksc end-bl1.xls (Size: 526 KB / Downloads: 366) RE: Deisn of End Block Reinforcement of Post-Tensioned Girder - ruaumoko - 12-04-2010 Friend, can you refer which code rules or manual calculation of this example? Thank you RE: Deisn of End Block Reinforcement of Post-Tensioned Girder - kowheng - 12-04-2010 End block reinforcement was designed by working stresses method, any code where they specify allowable tensile stress of steel, allowable compressive stress of concrete can be applied. Regards, |