Post-Tensioned Beam Design - Printable Version

Post-Tensioned Beam Design - Printable Version

+- Civil Engineering Association (https://forum.civilea.com)
+-- Forum: Civil Engineering Resource (https://forum.civilea.com/forum-1.html)
+--- Forum: Civil Engineering Documents (https://forum.civilea.com/forum-89.html)
+---- Forum: Calculation Notes & Analysis Files (https://forum.civilea.com/forum-80.html)
+---- Thread: Post-Tensioned Beam Design (/thread-18648.html)

Post-Tensioned Beam Design - deadlord - 11-14-2010

Post-Tensioned Beam Design

A full design example of a three span,single level parking structure T-beam example.
Presented by Professor Bijan O Aalami based on ACI 318-02 and IBC 2003.

Design steps:
1)Preliminary Steps:
a.Member thickness.
b.Cover to rebar and prestressing.

2)Computational Steps:
a.Geometry and structural system.
b.Material properties.
c.Loading.
d.Design parameters.
e.Actions due to dead and live loads.
f.Actions due to post-tensioning.
g.Stress check for serviceability.
h.Minimum passive reinforcement.
i.Strength calculation for bending.
j.Shear design.
k.Deflection check.
l.Stresses at transfer.
m.Tendon and reinforcement layout.
n.Computer solution.

Note: sorry again for my lack of skills in combining multiple pictures into a Pdf,I would greatly appreciate it if someone recommends Me how to do it on my profile comments.

[Image: Download.png]

Code:
***************************************

Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html

***************************************

RE: Post-Tensioned Beam Design - kowheng - 11-14-2010

Mirror Links:
[Image: Download.png]

Single PDF|RAR 3.90|3.59MB

Code:
***************************************

Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html

***************************************

RE: Post-Tensioned Beam Design - Dell_Brett - 11-14-2010

Some tips and considerations:

1- Use JPG file format for the images, instead of BMP file format. It's 10x smaller!

2- To create a simple PDF file, like a book, use a PDF file generator, like doPDF. To use it, just install the virtual printer (doPDF), open your text editor, put each image in a single full page and print "as PDF".

Code:
***************************************

Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html

***************************************

3- I's important that you mention in your post that is a ADAPT manual part!

Regards and keep active! Good posts!

Dell Brett