Steel Member Reinforcing, Reinforcement Analysis - Printable Version +- Civil Engineering Association (https://forum.civilea.com) +-- Forum: Civil Engineering Resource (https://forum.civilea.com/forum-1.html) +--- Forum: Civil Engineering Documents (https://forum.civilea.com/forum-89.html) +---- Forum: Engineering Spreadsheet (https://forum.civilea.com/forum-43.html) +---- Thread: Steel Member Reinforcing, Reinforcement Analysis (/thread-18632.html) |
Steel Member Reinforcing, Reinforcement Analysis - usman - 11-13-2010 Steel Member Reinforcing, Reinforcement Analysis
Spreadsheet program written in MS-Excel for the purpose of analysis and code checking of steel members with various types of reinforcement configurations. Specifically, members are analyzed / code checked per the AISC 9th Edition Allowable Stress Design (ASD) Manual. Both actual and allowable stresses are computed, with the final result being a computed "stress ratio" of actual stress/allowable stress. Both the intermediate and end weld requirements for attaching the reinforcing to the existing member are determined.
Analysis of Existing Member Reinforced with: - Plate at Bottom - WT Section at Bottom - I-Beam at Bottom - 4 Symmetric Angles - 4 Symmetric Round Bars - Top & Bottom Plates - 2 WT's (webs toed in) - 2 WT's (webs toed out) Code: *************************************** RE: Steel Member Reinforcing, Reinforcement Analysis - Dell_Brett - 07-14-2013 *************************************** Code: *************************************** RE: Steel Member Reinforcing, Reinforcement Analysis - cheadara - 11-27-2014 Dead Links Could you please repost? Thanks. RE: Steel Member Reinforcing, Reinforcement Analysis - ykhackhack - 11-27-2014 Code: *************************************** included in these spreadsheets |