+- Civil Engineering Association (https://forum.civilea.com)
+-- Forum: Software (https://forum.civilea.com/forum-65.html)
+--- Forum: Software Installation Problems & Bugs (https://forum.civilea.com/forum-106.html)
+---- Forum: Archive Problem (https://forum.civilea.com/forum-28.html)
+---- Thread: Built-up I section in Graitec Advance Steel (/thread-14827.html)
Built-up I section in Graitec Advance Steel - yucapareja - 07-31-2010
Hello,
How can I do a built-up I section in GAS as a shape (not 3 plates together)?
This is what I want to do:
![[Image: 93504586009767091222.jpg]](https://pic.civilea.com/images/93504586009767091222.jpg)
Thanks in Advance
RE: Built-up I section in Graitec Advance Steel - nexis35 - 08-04-2010
in
Code:
***************************************
Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:
http://forum.civilea.com/thread-27464.html
***************************************see page 113-115