Civil Engineering Association

Civil Engineering Association > Civil Engineering Resource > Civil Engineering Documents > Calculation Notes & Analysis Files > how we can assign to auto section
Full Version: how we can assign to auto section
You're currently viewing a stripped down version of our content. View the full version with proper formatting.

preceptor

11-22-2009, 10:20 PM
HOW WE CAN ASSIGN TO AUTO SECTION WITH SAP2000

[Image: 29452871947266729249.jpg]

[Image: info.png]
Here are a example
with steel sections
i used european sections where a simple building system,
this example about analysis,design and assign auto section


[Image: screen.png]
[Image: 56348742173972366984.jpg]

[Image: Download.png]

Code:
***************************************
Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html
***************************************

[Image: password.png]

Code:
***************************************
Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html
***************************************
note that
i used sap2000 8.33 advanced
and i tested it.
working properly(just like original sap2000 8 version)
if you want to use sap2000 8.33 advanced,you can find this forum
regards
Civil Engineering Association > Civil Engineering Resource > Civil Engineering Documents > Calculation Notes & Analysis Files > how we can assign to auto section