Civil Engineering Association

AWS A5.35/A5.35M-2015 AMD1: Specification for Covered Electrodes for Underwater Wet Shielded Metal Arc Welding

AWS A5.35/A5.35M, 2015 Edition, 2015 - Specification for Covered Electrodes for Underwater Wet Shielded Metal Arc Welding

This specification prescribes requirements for the classification, based on underwater wet welding test and associated evaluation, of covered electrodes for underwater wet shielded metal arc welding. Requirements for certification of test results are also shown herein. The specification covers ferritic steel, austenitic stainless steel, and nickel filler metals plus any auxiliary coatings applied over the electrode covering. Unless otherwise specified herein, the term “manufacturer” refers to the provider of the finished product (the electrode ready for underwater use). The requirements herein are intended to classify electrodes without consideration for potential base metals to be welded; suitability for specific base metals should be established by the customer during welding procedure qualification testing (see Annex A for further considerations).

This specification does not govern depth of water capability or maximum exposure time for wet welding electrodes classified to this document. However, such information shall be clearly shown as required by the marking requirements of Clause 14.

Safety and health issues and concerns are beyond the scope of this standard and, therefore, are not fully addressed herein. Some safety and health information can be found in informative Annex A. Safety and health information is available from other sources, including, but not limited to, ANSI Z49.1, Safety in Welding, Cutting, and Allied Processes, and applicable federal and state regulations.

Code:
***************************************

Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html

***************************************

Code:
***************************************

Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html

***************************************

Code:
***************************************

Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html

***************************************

This post has been made by CivilEA Post-Generator V2.4.2

Wrong files attached.

(08-24-2023, 02:40 AM)whysx Wrote: [ -> ]Wrong files attached.

TNX for report. replaced.

poolmand

whysx

poolmand