Civil Engineering Association

ACI_Check of Max. Crack width for M & N for both Rec. & T sections_ DAR excel sheet

ACI_Check of Max. Crack width for M & N for both Rec. & T sections_ DAR excel sheet

NOTE:
the sheet is perfect for calculating crack width,
(my opinion Happy

) is to compare the calculated w cr value with the given in ACI 224r-01, (Table 4.1—Guide to reasonable* crack widths, reinforced concrete under service loads).
Wink

in my copy i replaced the table at the end of the sheet with ACI 224r-01, (Table 4.1)

Code:
***************************************

Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html

***************************************

Code:
***************************************

Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html

***************************************

This post has been made by CivilEA Post-Generator v2.2.0

bigone