Civil Engineering Association

Wind Turbines
Part 1: Design Requirements
BS En 61400-1:2005

[Image: 71722433476967700849.jpg]

Code:
***************************************

Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html

***************************************

EN ISO/IEC 61400 Wind turbines

Contents:
EN ISO/IEC 61400-2:2006 Wind turbines -- Part 2: Design requirements for small wind turbines

EN ISO/IEC 61400-3:2009 Wind turbines -- Part 3: Design requirements for offshore wind turbines
IEC 61400-3:2009 specifies additional requirements for assessment of the external conditions at an offshore wind turbine site and specifies essential design requirements to ensure the engineering integrity of offshore wind turbines. Its purpose is to provide an appropriate level of protection against damage from all hazards during the planned lifetime. Focuses on the engineering integrity of the structural components of an offshore wind turbine but is also concerned with subsystems such as control and protection mechanisms, internal electrical systems and mechanical systems. It should be used together with the appropriate IEC and ISO standards, in particular with IEC 61400-1. This publication is to be read in conjunction with <a href=''http://webstore.iec.ch/webstore/webstore.nsf/artnum/037855''>IEC 61400-1:2005</a>.

EN ISO/IEC 61400-11:2003 Wind turbine generator systems -- Part 11: Acoustic noise measurement techniques
Presents measurement procedures that enable noise emissions of a wind tubine to be characterized with respect to a range of wind speeds and directions. Allows comparisons between different wind turbines. May be applied by wind turbine manufacturers, purchasers, operators and planners or regulators.

DD IEC TS 61400-13:2001, IEC TS 61400-13:2001 Measurement of mechanical loads

ISO/IEC TS 61400-14 Wind turbines – Part 14: Declaration of apparent sound power level and tonality values
This part of IEC 61400 gives guidelines for declaring the apparent sound power level and
tonality of a batch of wind turbines. The measurement procedures for apparent sound power level and tonality are defined in IEC 61400-11.

EN 61400-21:2008 Wind turbines -- Part 21: Measurement and assessment of power quality characteristics of grid connected wind turbines
IEC 61400-21:2008 covers the definition and specification of the quantities to be determined for characterizing the power quality of a grid connected wind turbine; measurement procedures for quantifying the characteristics; and procedures for assessing compliance with power quality requirements, including estimation of the power quality expected from the wind turbine type. The main changes with respect to the previous edition deal with interharmonics and current distortions (<9 kHz); response to voltage dips; active power ramp rate limitation and set-point control; reactive power capabilities and set-point control; grid protection and reconnection time after grid faults.

Draft IEC 61400-22: Wind turbine certification

EN ISO/IEC 61400-25-1:2007 Wind turbines -- Part 25-1: Communications for monitoring and control of wind power plants - Overall description of principles and models

EN ISO/IEC 61400-25-2:2007 Wind turbines -- Part 25-2: Communications for monitoring and control of wind power plants - Information models

EN ISO/IEC 61400-25-3:2007 Wind turbines -- Part 25-3: Communications for monitoring and control of wind power plants - Information exchange models

EN ISO/IEC 61400-25-4:2008 Wind turbines -- Part 25-4: Communications for monitoring and control of wind power plants - Mapping to communication profile

EN ISO/IEC 61400-25-3:2007 Wind turbines -- Part 25-5: Communications for monitoring and control of wind power plants - Conformance testing

Dear friends, if someone of you has the missing standards from this standard series, please share it.

[Image: Download.png]

Code:
***************************************

Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html

***************************************

Code:
***************************************

Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html

***************************************

BS EN 61400-2:2006 Wind turbines Part 2: Design requirements for small wind turbines (IEC 61400-2:2006)

This part of IEC 61400 deals with safety philosophy, quality assurance, and engineering integrity and specifies requirements for the safety of Small Wind Turbines (SWTs) including design, installation, maintenance and operation under specified external conditions. Its purpose is to provide the appropriate level of protection against damage from hazards from these systems during their planned lifetime.

This part of IEC 61400 is concerned with all subsystems of SWT such as protection mechanisms, internal electrical systems, mechanical systems, support structures, foundations and the electrical interconnection with the load.

While this part of IEC 61400 is similar to IEC 61400-1, it does simplify and make significant changes in order to be applicable to small turbines.

This part of IEC 61400 applies to wind turbines with a rotor swept area smaller than 200 sq. m, generating at a voltage below 1 000 V a.c. or 1 500 V d.c.

This part of IEC 61400 should be used together with the appropriate IEC and ISO standards.

Code:
***************************************

Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html

***************************************

Made By CivilEA Post-Generator ver 2.0

Moderator Note:
This file is present (first) in the link posted above

New working links, the password is the same like in post #1.

Code:
***************************************

Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html

***************************************

Code:
***************************************

Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html

***************************************

BS EN 61400-2:2006 Wind turbines Part 2: Design requirements for small wind turbines (IEC 61400-2:2006)

Code:
***************************************

Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html

***************************************

Code:
***************************************

Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html

***************************************

This post has been made by CivilEA Post-Generator v2.2.0

BS EN 61400-2:2006

Code:
***************************************

Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html

***************************************

Arigato

ir_71

datagap

ir_71

arshiakh

lisine