Civil Engineering Association

Hi,
I'm looking for ISO 898-2 Mechanical properties of fasteners -- Part 2: Nuts with specified proof load values

Thanks.

ISO 898-2:1992 Mechanical properties of fasteners -- Part 2: Nuts with specified proof load values -- Coarse thread

Applies to nuts with nominal thread diameters up to and including 39 mm, specific mechanical requirements, widths across flats as specified in ISO 272, nominal heights greater than or equal to half the nominal diameter of the internal thread, made of carbon steel or low alloy steel. Does not apply to nuts requiring special properties (such as weldability, corrosion resistance, etc.). Values apply when tests are made at room temperature.

Code:
***************************************

Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html

***************************************

Made By CivilEA Post-Generator ver 2.1

And here you can find the current edition ISO 898-2:2012

Code:
***************************************

Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html

***************************************

the pass:

Code:
***************************************

Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html

***************************************

Civil Engineering Association

tunc

ir_71

st77bel