Civil Engineering Association

BS EN 10034:1993 Structural steel I and H sections - Tolerances on shape and dimensions

This European Standard specifies tolerances on shape dimensions and mass of structural steel I and H sections. These requirements do not apply to I and H sections rolled from stainless steel. These requirements do not apply to taper flange sections.

NOTE Until a European Standard for dimensions of I and H beams is published Euronorm19 and Euronorm53 or corresponding national standards may be used.

Code:
***************************************

Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html

***************************************

Made By CivilEA Post-Generator ver 2.0

links dead; reposted here:

Code:
***************************************

Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html

***************************************

pass:

Code:
***************************************

Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html

***************************************

ir_71

andersen3