Civil Engineering Association

PD 8010-2:2004 Code of practice for pipelines - Part 2: Subsea pipelines

This part of PD 8010 gives recommendations for and guidance on the design, use of materials, construction,
installation, testing, commissioning and abandonment of carbon steel subsea pipelines in offshore,
nearshore and landfall environments. Guidance on the use of flexible composite pipelines is also given.
It is not intended to replace or duplicate hydraulic, mechanical or structural design manuals.
This part of PD 8010 is applicable to subsea pipelines intended for the conveyance of hydrocarbon liquids,
hydrocarbon gases and other gases, liquids and gases in two-phase flow, fluid-based slurries and water.
NOTE Although primarily concerned with subsea pipelines associated with the oil and gas industry, PD 8010-2 is likely to have
application to a wider range of offshore activities.
The extent of pipeline systems covered by this part of PD 8010 is shown in Figure 1.
This part of PD 8010 does not give recommendations for pipelines on land, which are covered in PD 8010-1.
It does not cover sea outfalls (see BS EN 752-4) or fluid umbilicals (see BS 5173).

Code:
***************************************

Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html

***************************************

Made By CivilEA Post-Generator ver 2.0

New links:

Code:
***************************************

Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html

***************************************

ir_71

ir_71