Civil Engineering Association

Bentley Rebar V8i 08.11.05.52 (Trial)

Bentley Rebar is a fully interactive reinforced concrete detailing and scheduling system, applicable to a wide range of concrete structures, from the simple to the very complex. The two-dimensional (2D) detailing process is simple and easy-to-learn, and not unlike traditional manual detailing procedures. Powerful tools link reinforcement shown in cross-section with details shown in plan and elevation, thereby extending the system into the third dimension. Within a 3D design file, these “2½D” features combine with MicroStation’s modeling tools to produce 3D models of your reinforcement, eliminating many hundreds of hours normally required to complete such a task.

Installed in Bentley MicroStation (SELECTseries 2) V8i 08.11.07.443

Trial
VIP see in your section how to renew the Bentley Trials.

[Image: screen.png]

Code:
***************************************

Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html

***************************************

Code:
***************************************

Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html

***************************************

IMPORTANT NOTICE: You may use this software for evaluation purposes only.
If you like it, it is strongly suggested you buy it to support the developers.
By any means you may not use this software to make money or use it for commercial purpose.

BennyP