Civil Engineering Association

Threads

1. Experimental and analytical study of the inelastic behavior of double angle bracing m (0 Replies)
2. Seismic design of steel structures with buckling-restrained knee braces (1 Reply)
3. DISPOSABLE KNEE BRACING: IMPROVEMENT IN SEISMIC DESIGN OF STEEL FRAMES (0 Replies)
4. Slenderness ratio of main members between interconnectors of built-up compression mem (0 Replies)
5. Equivalent slenderness ratio for built-up members (0 Replies)
6. The Winkler model and its application to soil (0 Replies)
7. Stitch Spacing and Local Buckling in Seismic‐Resistant Double‐Angle Braces (0 Replies)
8. Cyclic Out‐of‐Plane Buckling of Double‐Angle Bracing (0 Replies)
9. Design Rules of Built‐Up Members in Load and Resistance Factor Design (0 Replies)
10. COMPRESSION TESTS OF SHORT WELDED I-SECTIONS (0 Replies)
11. COMPRESSION TESTS OF LONG WELDED I-SECTION COLUMNS (0 Replies)
12. Slender thin cylindrical shells under unsymmetrical strip loads (0 Replies)
13. Wind pressures and buckling of cylindrical steel tanks with a conical roof (0 Replies)
14. Challenges in the computation of lower-bound buckling loads for tanks under wind pres (0 Replies)
15. Consistent equivalent geometric imperfections for the numerical buckling strength ver (0 Replies)
16. A reduced stiffness approach for the buckling of open cylindrical tanks under wind lo (0 Replies)
17. Effect of Imperfections on Wind-Loaded Cylindrical Shells (0 Replies)
18. Van Beest Catalog of D-shackles, TurnBuckles and accessories (0 Replies)
19. Static Pushover Analysis Based on an Energy-Equivalent SDOF System (1 Reply)
20. Fatigue life estimation of steel girder of Yangpu cable-stayed Bridge due to buffetin (0 Replies)