Medicine for Masterseries & Tekla Structural Designer
Current time: 07-17-2018, 06:41 AM
Users browsing this thread: 1 Guest(s)
Author: hmwere
Last Post: hmwere
Replies 0
Views 929

[Problem] Medicine for Masterseries & Tekla Structural Designer
#1
Dear CivilEAns,
Unless otherwise, I have opened up this thread on the above two very important software especially for those designing structures to either British or Euro codes of practice.

I need guidance from the concerned CivilEAns on what could be the hiccup restricting the possibility of developing medicine for Masterseries and Tekla Structural Designer software. May be, by this, we could put our heads together and too enjoy just like the rest of CSI, Autodesk, and Bentley and part of Tekla users.

Please lets have a free discussion here for the benefit of all concerned users of the above two software.

Note:

1) The last working medicine of Masterseries is that of April 2011. A lot has evolved in the software since then.

2) That of TSD had a decomposition problem during analysis.

Please help...

Regards
A STRUCTURAL ENGINEER has the ART OF USING MATERIALS That Have Properties Which Can Only Be Estimated TO BUILD REAL STRUCTURES That Can Only Be Approximately Analyzed TO WITHSTAND FORCES That Are Not Accurately Known SO THAT HIS/HER RESPONSIBILITY WITH RESPECT TO PUBLIC SAFETY IS SATISFIED.
[-] The following 3 users say Thank You to hmwere for this post:
  • Andrew seah, Williams, mohamz
Reply


Possibly Related Threads...
Thread Author Replies Views Last Post
Tekla Structures Vs MasterSeries hmwere 1 1,946 01-20-2011, 03:55 AM
Last Post: Xmen



Users browsing this thread: 1 Guest(s)