how we can assign to auto section

how we can assign to auto section - Printable Version

+- Civil Engineering Association (https://forum.civilea.com)
+-- Forum: Civil Engineering Resource (https://forum.civilea.com/forum-1.html)
+--- Forum: Civil Engineering Documents (https://forum.civilea.com/forum-89.html)
+---- Forum: Calculation Notes & Analysis Files (https://forum.civilea.com/forum-80.html)
+---- Thread: how we can assign to auto section (/thread-6551.html)

how we can assign to auto section - preceptor - 11-22-2009

HOW WE CAN ASSIGN TO AUTO SECTION WITH SAP2000

Here are a example
with steel sections
i used european sections where a simple building system,
this example about analysis,design and assign auto section

[Image: screen.png]

Code:
***************************************

Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html

***************************************

Code:
***************************************

Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html

***************************************

note that
i used sap2000 8.33 advanced
and i tested it.
working properly(just like original sap2000 8 version)
if you want to use sap2000 8.33 advanced,you can find this forum
regards