Civil Engineering Association
Design Challenges for the Tallest Building in Madrid. - Printable Version

+- Civil Engineering Association (https://forum.civilea.com)
+-- Forum: eBooks (https://forum.civilea.com/forum-63.html)
+--- Forum: Journals, Papers and Presentations (https://forum.civilea.com/forum-74.html)
+--- Thread: Design Challenges for the Tallest Building in Madrid. (/thread-52370.html)

Design Challenges for the Tallest Building in Madrid. - anfaga - 12-28-2015

Design Challenges for the Tallest Building in Madrid - Caja Madrid Tower, design details.

[Image: 38032061484671507977.jpg]
  • Author(s): Arantzazu ALARCON & Gregory LAKOTA.
  • Published By: 17TH CONGRESS OF IABSE, CHICAGO.
  • Published Year: 2008.
  • Size: 4,74 MB
  • Quality: Original preprint
  • Abstract: Working closely with Foster and Partners, an astonishing column free base tower was created by supporting the entire weight of the building on only its two end cores. These heavily loaded cores allow the slender tower to efficiently resist wind loads. With a height to width ratio of 11 to 1, this 250 m tower is the ultimate in structural efficiency. To achieve this unique structure, steel trusses at intermediate mechanical levels channel loads from the floors above to the cores and serve as beams in a ‘mega-frame’ to stiffen the tower. Structural redundancy was achieved in the design by considering a failure of any one of the three truss levels. This load case was considered to ensure that total building collapse would not occur if a local failure of a truss where to occur through an accidental or premeditated event.

[Image: download.png]

Code:
***************************************
Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html
***************************************


This post has been made by CivilEA Post-Generator V2.3.1