Civil Engineering Association
Shear Wall Highly Stress at Corner - Printable Version

+- Civil Engineering Association (https://forum.civilea.com)
+-- Forum: Software (https://forum.civilea.com/forum-65.html)
+--- Forum: Software Installation Problems & Bugs (https://forum.civilea.com/forum-106.html)
+---- Forum: Archive Problem (https://forum.civilea.com/forum-28.html)
+---- Thread: Shear Wall Highly Stress at Corner (/thread-17901.html)

Pages: 1 2 3


Shear Wall Highly Stress at Corner - techno - 10-21-2010

Anyone please guide me on how to cater the high stress at wall corner? My analysis is from ETABS.


RE: Shear Wall Highly Stress at Corner - aslam - 10-21-2010

Provide BOUNDARY ELEMENTS at corners


RE: Shear Wall Highly Stress at Corner - techno - 10-21-2010

Dear Aslam, could you please explain clearly?


RE: Shear Wall Highly Stress at Corner - chrono146 - 10-21-2010

Hello,

Check ACI 318 chapter 21, there you can find requirements for boundary elements.

Regards,


RE: Shear Wall Highly Stress at Corner - mdmh10 - 10-21-2010

If you are asking how to do it at the corners look at the CSI Etabs video for Shear Walls Meshing:
Code:
***************************************
Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:

http://forum.civilea.com/thread-27464.html
***************************************
Select the: Wall Meshing (6 min) video.

I hope this answers your question.

Cheers,
MDMH


RE: Shear Wall Highly Stress at Corner - techno - 10-22-2010

mdmh10 : i am not talking about meshing. There is no problem with my mesh. If u have the experience for designing shear wall b4 then definitely u will notice that the wall's corner will be highly stressed (compression).

Chrono146: Could u please explain into details and give an example. (is that what you mean to add a support at the corner?




RE: Shear Wall Highly Stress at Corner - seb3k - 10-22-2010

It is just an imperfection of FEM method.
Use values that are a bit further from the edge.


RE: Shear Wall Highly Stress at Corner - techno - 10-22-2010

Are u sure i can use the value which is further from the corner? Could any members give some comments? how further from the edge should we use?
For example, in a 500x500mm wall element, i found that the value at corner is 3599KN/m but at the middle of the element, it's actually just 2000KN/m.



RE: Shear Wall Highly Stress at Corner - chigozie - 10-22-2010

If I understand you well, I think, you are talking of increased stresses that result due to the intersection of stresses from the walls that meet at the corner. If that is the case, provide extra corner reinforcement.
Regards
Teddy



RE: Shear Wall Highly Stress at Corner - techno - 10-22-2010

Not necessary to be walls meet at corner. For example,20 storey high RC Wall which sitting on the strip beam and the beam is supported by piles. So, when i look at the axial load of the wall from Elevation, it shows me a very high stress at both corner. How to cater this large axial force?