Plate Girder in SAP 2000 - Printable Version +- Civil Engineering Association (https://forum.civilea.com) +-- Forum: Software (https://forum.civilea.com/forum-65.html) +--- Forum: Software Installation Problems & Bugs (https://forum.civilea.com/forum-106.html) +---- Forum: Archive Problem (https://forum.civilea.com/forum-28.html) +---- Thread: Plate Girder in SAP 2000 (/thread-17236.html) |
Plate Girder in SAP 2000 - sherkhan - 10-02-2010 Dear all. I have been trying to model steel structures in SAP 2000. Could anyone throw some light on modeling a builtup section for a plate gorder WITH STIFFNERS? Without stiffners I can create the section within SAP 2000 general section builder. However, if I have vertical stiffners sau angles are welded to the plate girder at a distace of say 1 m each, its getting complicated or may be I dont know how to model it correctly. Its a welded plate girder. In addition does anyone has some idea on mdeling moving loads from a 4 wheel crane loads on a girder...kind of Gantry girder. Thanks in advance Sher |