+- Civil Engineering Association (https://forum.civilea.com)
+-- Forum: Software (https://forum.civilea.com/forum-65.html)
+--- Forum: Software Installation Problems & Bugs (https://forum.civilea.com/forum-106.html)
+---- Forum: Archive Problem (https://forum.civilea.com/forum-28.html)
+---- Thread: Etabs auto wind load (/thread-15785.html)
Etabs auto wind load - skyscraper - 09-01-2010
We use Australian Codes for wnd load design which is not supported in Etabs. To generate this load using ASCE7-02 static wind loads, I modify gust factor =1.05 while other factors according to AS codes required. Could someone tell me my approaching is correct or not?
Regards
RE: Etabs auto wind load - nuttapolk - 09-02-2010
I am not sure but the first thing is to check the basic wind speed. Some code use gust wind speed some code use mean hourly wind speed. If not same. we need to convert it. I guess this 2 code use same ref wind speed.
Second thing is the zone for pressure coefficient is not the same for these 2 code. May be Australia Codes divides area in to more zones.
If it is necessary to use Australia code, So i think we can use auto wind load (may be asce) with dummy wall to define pressure coefficient.
RE: Etabs auto wind load - skyscraper - 09-02-2010
Thanks, have we got any formulas to convert thw basic wind speed from 3s gust to 10m gust? I believe that since this is solvable, we can convert in equivalent.
Any ideas
RE: Etabs auto wind load - nuttapolk - 09-06-2010
Yes there is a chart in ASCE7 to convert gust wind speed to hourly wind speed.
Code:
***************************************
Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:
http://forum.civilea.com/thread-27464.html
***************************************RE: Etabs auto wind load - visu - 09-07-2010
ASCE using 3s gust and BS 6399 using Mean Hourly Wind Speed. I am not sure about 10m gust. It is to highlight that 3s gust wind speed to be measured at 10m from the ground level.
RE: Etabs auto wind load - nuttapolk - 09-07-2010
I think may be it is 10s gust. Some countries use 10s gust for basic wind speed.
Moderator Notes:
Please use "NEW REPLY" button next time. You may be warned for spamming if you kept replying with "REPLY" button (quoted text without good reason).