Hi there fellow civil engineers. I would like to ask if you have some example for the design of base plates with rib plates. As of now I only have AIJ coefficients and some Timoshenko et al coefficients to design and check for the moment capacity of base plates. As of now I'm comparing the AIJ results to Timoshenko coeff results, but not all sides were available in Timoshenko, for example a portion with 3 sides fixed and 1 side free. Can you please share your own design procedure or if you are familiar about this can you please share your knowledge. Thanks!
Hi
in "AISC Design Guide 01 - Base Plate And Anchor Rod Design" is some good information about this topic
if you dont have it tell me by email to forward this PDF Guide file
this is good refrence
check this
Beam-Column Base Plate Design
Code:
***************************************
Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:
http://forum.civilea.com/thread-27464.html
***************************************
You may also use this simple spread sheet based on US code. The steel sections are US.
Code:
***************************************
Content of this section is hidden, You must be registered and activate your account to see this content. See this link to read how you can remove this limitation:
http://forum.civilea.com/thread-27464.html
***************************************