05-03-2011, 10:31 PM
05-05-2011, 02:04 PM
You can start by looking at the diagram tab there are plenty that you can start with.
for example:
Shift N - toggle on/off node number
Shift B - toggle on/off beam number
Shift S - toggle on/off support
etc.....
there are plenty more but you have to start with the basic and commonly used ones.
for example:
Shift N - toggle on/off node number
Shift B - toggle on/off beam number
Shift S - toggle on/off support
etc.....
there are plenty more but you have to start with the basic and commonly used ones.
05-07-2011, 09:20 PM
there are many. and you can find it our easily. for example if you open the symbols and lable button. you will find all the option with a letter (). use this in combination with Shift.. there you go..
for eg. Shift+V - for Load values display
shift+......
the most useful i see is the Alt+V - This lets you to see only the members/plates you selected.
this if for the view purpose and fast.
for analysis its Ctrl+F5 (as it reads on the toolbar). so essentially you can building a easy reference sheet for all the shortcuts, in meantime you will get used to them. all the best.
for eg. Shift+V - for Load values display
shift+......
the most useful i see is the Alt+V - This lets you to see only the members/plates you selected.
this if for the view purpose and fast.
for analysis its Ctrl+F5 (as it reads on the toolbar). so essentially you can building a easy reference sheet for all the shortcuts, in meantime you will get used to them. all the best.